Posts tagged as:

8600

Avaya ERS 8600 Software 7.0 Draft Release Notes

by Adam DaCosta

Avaya ERS 8600 Software 7.0 Draft Release Notes.

Read the full article →

With the ERS 8600, what are the differences between an R and RS module?

by dgorham

The main difference between the two types of modules is that the RS modules use new hardware and software to provide enhanced QoS and port mirroring capabilities.

Read the full article →

Nortel Avaya – 5.1.1.1 Release notes – Upgrading pair of IST Core peer switches

by dgorham

Some things learned, READ the release notes, don’t assume anything even if you have done it a thousand times before! #1  (From 5.1.1.1 release notes) [singlepic id=32 w=320 h=240 mode=web20 float=left]When upgrading a pair of IST Core peer switches, special care must be taken due to SMLT architectural change. Unlike previous upgrades, when moving from [...]

Read the full article →

Nortel – Avaya – Resilient Multicast Routing Using Split-Multilink Trunking for the ERS 8600

by Combat Joe

[singlepic id=32 w=320 h=240 float=left]Description: This Technical Configuration Guide (TCG) describes the supported network designs and configurations for Protocol Independent Multicast Sparse Mode (PIM-SM) over Nortel’s Split Multi-Link Trunking for the Ethernet Routing Switch 8600. All configuration examples are based on the minimum software and hardware level as shown below. Switch Software Level ERS8600 4.1. [...]

Read the full article →

Jumbo Frames… Is bigger better?

by Troy Johnson

Jumbo frames are like a double quarter pounder, more meat with less bun overhead. (Jumbo frames typically refer to Ethernet frames with larger than the standard 1500 byte payload and are a feature of Gigabit Ethernet.) It sounds great in principle but there are caveats.   For jumbo frames to work without issues the end devices [...]

Read the full article →